How to Install WLED on HiLetGo ESP32 Board

How to Install WLED on HiLetGo ESP32 Board

Edited Version 2

---

To install WLED on a HiLetGo ESP32 board, you will need the following
* A HiLetGo ESP32 board * A computer with the Arduino IDE installed * A USB cable to connect the ESP32 board to the computer * The latest version of the WLED library for ESP32 Here are the steps to install WLED on your HiLetGo ESP32 board
1. Connect the ESP32 board to the computer using a USB cable. 2. Open the Arduino IDE and select "Tools" > "Board" > "ESP32". 3. Select "Tools" > "Programmer" > "ESP8266/ESP32 UART". 4. In the "Tools" menu, select "Burn Bootloader" to burn a bootloader on the ESP32 board. This will allow you to upload firmware to the board using a serial connection. 5. Once the bootloader has been burned, disconnect the ESP32 board from the computer and connect it to a power source. 6. Open the Arduino IDE and select "File" > "Ex